Kenty PDF

Futaba GY Pdf User Manuals. View online or download Futaba GY Instruction Manual. Nstruction, Anual • Read online or download PDF • Futaba GY User Manual. The chart below works for almost all helicopters but you should consult your helicopter manual if you are not sure. Note that I have seen.

Author: Mejind Zugore
Country: Jamaica
Language: English (Spanish)
Genre: Career
Published (Last): 20 May 2015
Pages: 484
PDF File Size: 9.97 Mb
ePub File Size: 15.13 Mb
ISBN: 733-7-55646-607-3
Downloads: 71125
Price: Free* [*Free Regsitration Required]
Uploader: Goltigrel

If not, hold the button down to enter setup manuql. I was helping my buddy and he wanted me to hover it, so as soon as I did, the tail was super wobbly.

When you move the rudder stick to the right, it will move the trailing edge of the tail blades to the right side of the helicopter. In the picture, Aux2 is set to INH but this does not matter for this gyro setup. Release the button and you will see the gyro gyy520 repeat a ‘1 blink’. This would be very simple for Futaba to have done and would save some confusion. I fly smooth 3D and prefer the slower rotation rate.

For now set both to 50 but later you may need to adjust this up or down a little to get the best performance. Note that I have seen common problems with the tail blades grips flipped the wrong direction and the tail belt twisted the wrong direction. You may want it faster or slower so change the value appropiately. Watch the light on the gyro, when you move the rudder stick from center, the light needs to change from a solid color to a flashing violet.

  A ROCK CLIMBING GUIDEBOOK FOR ANTALYA PDF

Also make sure that your plugs in the receiver have the correct polarity. Make sure when you are adjusting the tail control rod links that you do not get too much of the threads showing.

Futaba GY Manuals

There is an error in the instructions which has been corrected on Futaba’s FAQ page. One direction will be blue and the other direction is red. Then the light will stay on solid. Use the ‘clear’ button to set the values to zero.

For small class helis use the thin g5y20 pad. At the left, look at the top picture. Back to Main Page. From the previous step the gyro should be on and in a 3-blink mode. The gyro repeats a ‘2 blink’. Look at the picture on the right. The color of this 4-Blink indicates the mode it is in.

Check the holes in the arm for one that is 90 degrees to the tail control rod. This will save the setting. This g520 going to vary for different helicopters and different brand servos.

Futaba GY520 User Manual

Power up the radio and the receiver. Hold in the button on the gyro for three seconds.

  JIS B1188 PDF

Do not tie the soft rubber line down to the helicopter, close to the gyro. It also depends on how the link connects to the servo.

Just hold it on top of the ball. Heading Hold Solid Blue: This tells the radio that you want to control the Gear channel of the receiver by using the switch on the radio that is labeled Gear. If you use the two leads that it came with, the black one will connect to the side I labeled Rudder in the picture and the red will connect to the Gear gain side. If you did not see a change then a common mistake is you got the rudder and gain wires switched around.

You should make the decision based on what your flying style is. Standard Rate mode Flip the Gear switch up position 0 and confirm that the light on the gyro is solid red. One direction will set the gain value for heading hold and the other will be for standard rate.

Please provide as much info as you can.